प्रकाश और हार्डवेयर के लिए सर्कल

Typical applications

Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.

• Lighting — downlight reflectors, lamp pans, housing bases
• Hardware — lock plates, hinge shims, decorative caps
• Appliance parts — heating plates, fan guards

Selection FAQ

Will thin gauge crack when stamped?

It depends on the draw ratio and the die. 0.3–0.5 mm 304 draws well for shallow parts; for deep drawing use 304 rather than 201.

Can the discs be pre-polished?

Yes on request, but polishing before stamping tends to leave die marks — normally the part is formed first, then polished.